All Categories

  • All Categories
  • Raspberry Pi Zero / Zero W
  • Raspberry Pi Zero W
  • Case
  • Accessories
  • Phats & Hats
  • Displays
  • Others
  • Raspberry Pi & Co
  • Raspberry Pi
  • Case
  • Accessories
  • Phats & Hats
  • Displays
  • Camera
  • Others
  • MagPi
  • AIY
  • Google Aiy Kit
  • Arduino & Co
  • Arduino Boards
  • Shields
  • Accessories
  • Accessories
  • Displays
  • Wearable Tech
  • Camera
  • Others
  • Development Boards
  • ADAFRUIT
  • FEATHER
  • IOT
  • SENSORS
  • WEARABLES
  • ALTERA
  • AMBER WIRELESS
  • DIGI INTERNATIONAL
  • FPGA
  • Linkit
  • MICROCHIP
  • OLIMEX
  • SEED STUDIO
  • ARDUINO ADD ON
  • WAVESHARE
  • RASPBERRY PI
  • BeagleBone
  • Intel
  • STM/ARM
  • Teensy
  • Texas
  • FTDI
  • SILICON LABS
  • CYPRESS
  • MICROCHIP
  • Android Things
  • Shields
  • Hats
  • Project Kits
  • Boards
  • Sensors & Modules
  • Sensors
  • Biometric
  • Health
  • Modules
  • Others
  • Internet Of Things-IOT
  • Bluetooth
  • ESP8266
  • XBEE
  • RFID
  • NFC
  • Radio Frequency
  • Wireless
  • GSM
  • GPS
  • Shields
  • Others
  • Programming
  • Robotics
  • Gear Motors
  • Servos
  • Stepper
  • Wheels
  • Chasis
  • Remotes
  • Robotic Arm & Allied Products
  • Accessories
  • Quadcopter Kits & Spares
  • Frame
  • Motors
  • Propellers
  • Batteries
  • Remote
  • Flight Control Modules
  • Accessories
  • Quadcopter
  • 3D Printer Parts
  • Motors
  • Motor Drivers
  • Boards
  • Shields
  • Solenoid
  • Hot Beds
  • LCDs & Displays
  • Fabrication Tools
  • Cables
  • Prototype
  • Power
  • Batteries
  • Adaptors
  • Shields
  • Others
  • Electronic Components
  • ICs
  • Resistors
  • Transistors
  • Diodes
  • Transformer
  • Others
  • Industrial Automation
  • SMPS
  • Relays
  • Books
  • Tools
  • Kits
  • Silvered Box

Featured Products

Bestseller Products

Modules


Product Compare (0)

Rs.100

12V 2Ch Relay Module

rating
0 reviews
DescriptionModule descriptionMaximum load on normally open pin: AC 250V/10A, DC 30V/10A.Trigger current 5mAModule can be set high level or low level trigger by jumper wirePower indicator light (green), relay status indicator light (red)Module size: 50 x 41 x 18.5mmModule interface specificationsDC+ . . .Read more
Rs.335

16 channel Neopixel WS2812 5050 RGB LED lights Ambilight

rating
0 reviews
Description:Arduino,  Raspberry pi can directly Drive this no need external power.Can Be used to Create Ambilight for tv Intelligent reverse connect protection, the power supply reverse connection does not damage the IC. The control circuit and the LED share the only power source.&nbs . . .Read more
Rs.170

220V 2000W Speed Controller SCR Voltage Regulator Motor Speed Controller

rating
0 reviews
Connect this device with lamp or home appliance in a series connection, then rotate the knob for dimming, speed, voltage, temperature control. Applicable appliance: electric furnace, water heater, lamps, small motor, electric iron etc. Input voltage: 220V. Maximum power: 2000W. A . . .Read more
Rs.150

ADXL345 TRIPPLE AXIS ACCELEROMETER BOARD

rating
0 reviews
PRODUCT DESCRIPTIONADXL345 Tripple Axis Accelerometer Board is a small, thin, low power, 3-axis accelerometer with high resolution (13-bit) measurement at up to ±16g. Digital output data is format as 16-bit twos complement and is accessible through either a SPI (3- or 4-wire) or I2C digital interfa . . .Read more
Rs.150

BH1750 - Light Intensity Sensor Module

rating
0 reviews
Description:-BH1750 module is a digital ambient light sensor, IIC I2C communication. Good for arduino light detection. It is a  light intensity sensor breakout board with a 16 bit AD converter built-in which can directly output a digital signal, there is no need for complicated calculation . . .Read more
Rs.200

BMP 180

rating
0 reviews
The ultra-low power, low voltage electronics of the BMP180 is optimized for use in mobile phones, PDAs, GPS navigation devices and outdoor equipment. With a low altitude noise of merely 0.25m at fast conversion time, the BMP180 offers superior performance. The I2C interface allows for easy system in . . .Read more
Rs.150

CJMCU-123 WS2812 RGB LED Breakout Module

rating
0 reviews
This is a breakout board for the built in WS2812 RGB LED. The WS2812 is actually an RGB LED with a WS2811 built right into the LED! All the necessary pins are broken out to 0.1" spaced headers for easy bread-boarding. Several of these breakouts can be chained together to form a display or an address . . .Read more
Rs.250

Data Logger module Logging Shield data recorder shield

rating
0 reviews
Specifications and Features :SD card interface works with FAT16 or FAT32 formatted cards. 3.3v level shifter circuitry prevents damage to your SD card.Real-time clock (RTC) keeps the time going even when the Arduino is unplugged. The battery backup lasts for years.Included libraries and example code . . .Read more
Rs.330

DC Motor Speed Control Regulator Pulse PWM 12V-40V 10A

rating
0 reviews
The DC Motor Speed Controller allows controlling direction of a DC motor using a Pulse-Width-Modulated (PWM) DC voltage with a Duty Cycle fully adjustable from 0%-100%. The circuit also includes a 10A fuse, with reverse connection of power supply and control voltage over-voltage protection func . . .Read more